Which order is the brightest?

n = 0
n = 1
n = 2

One can calculate speed from the given data. The speed is 4.44m/s.

The speed is the ratio of distance and the time taken to cover that distance.

Given is the distance d =4km =4000m and the time taken t 15 min =15 x60 =900 s

Then the speed will be

s = d/t

s = 4000/900

s= 4.44 m/s

Thus, the speed is calculated as 4.44m/s.

Learn  more about speed.

https://brainly.com/question/7359669

#SPJ1

Answer:

The difference phase = 3 λ

In terms of wavelength the difference of phase is zero so the sources would experience "constructive" interphase at that point.

If the light from the sources differed by 1/2, 3/2, 5/2 wavelengths  etc, then the sources would be out of phase at that point.

Answer:

A force of μk⋅60N is needed to keep a 60-newton rubber block moving across level, dry asphalt in a straight line at a constant speed.

Explanation:

Answer:  there is no shadow on the Moon with the solar eclipse.

Explanation: When the Moon passes between the Earth and the Sun, it casts a moving shadow on the Earth's surface, known as a solar eclipse. When the Earth passes between the Sun and the Moon, a lunar eclipse occurs, creating a shadow on the Moon.

When two charged plates are separated by a distance, the potential difference between the plates is 54 Volts.

The electric field intensity which does not increase or decrease with time or remain constant is called the uniform electric field.

Given is the plates separated by distance d = 15 cm =0.15 m, electric field E= 360 N/C.

The relation between the electric field and voltage is

E=V/d

Substitute the values into the expression to get the potential difference V,

V = 360 x 0.15

V = 54 Volts

Thus, the potential difference between the plates is 54 Volts.

Learn more about uniform electric field.

https://brainly.com/question/26446532

#SPJ1

Coal, followed by gas is the largest source of electricity

Coal is the world’s biggest source of electricity production.

The world's biggest source of electricity production is Coal. Coal is a fossil fuel that is mined from the ground and is the largest source of energy for the generation of electricity worldwide. Coal is burned to produce heat, which is then used to boil water and produce steam. The steam drives turbines that generate electricity.

There are other sources of electricity as well, such as natural gas, nuclear energy, hydroelectric power, and renewable energy sources like wind and solar power.

However, coal is the largest source of electricity production in the world.

The final temperature of the mixture after thermal equilibrium is reached given the data is 40.4 °C

Heat loss = Heat gain

MC(T – Tₑ) = MᵥᵥCᵥᵥ(Tₑ – Tᵥᵥ)

40.1 × 0.45(652 – Tₑ) = 328 × 4.184(Tₑ – 32.4)

18.045(652 – Tₑ) = 1372.352(Tₑ – 32.5)

Clear bracket

11765.34 – 18.045Tₑ = 1372.352Tₑ – 44464.2048

Collect like terms

11765.34 + 44464.2048 = 1372.352Tₑ + 18.045Tₑ

56229.5448 = 1390.397Tₑ

Divide both side by 1390.397

Tₑ = 56229.5448 / 1390.397

Tₑ = 40.4 °C

Learn more about heat transfer:

https://brainly.com/question/6363778

#SPJ1

we can use 3 formula for inclined plane

W=-ΔPE

W=ΔKE

W=mg sinθ. d

let's use the third formula

sinθ = 1.2 : 3

sinθ = = 0.4

W = m.g. sinθ. d

W = 110 x 10 x 0.4 x 3

W = 1320 J

x max = (vi² sin 2α) / g

x max = (6.25² sin 90)/10

x max = 39.0625/10 = 3.91 m

Answer:

The gravitational force on the moon is less than on Earth because the strength of gravity is determined by an object's mass. The bigger the object, the bigger the gravitational force. Gravity is pretty much everywhere. We just feel it in different ways depending on our state of motion.

Explanation:

Hope this helped!!

Answer:

they use a spaceship plus oxygen space has a gravitational force

Thermal energy from the injured area transfers to the ice and the thermal energy transferred in this scenario is conduction.

Conduction heat transfer is the transfer of heat through matter such as  solids, liquids, or gases without bulk motion of the matter.

The  ice pack absorbs the heat energy without the actual movement of the molecules of the ice pack.

Thus, thermal energy from the injured area transfers to the ice and the thermal energy transferred in this scenario is conduction.

Learn more about conduction here: https://brainly.com/question/893656

#SPJ1

Answer:

1. What is the best description of thermal energy?

B) Thermal energy is the energy in matter due to the movement of its atoms and/or molecules.

2. An athlete hurts their wrist. They put an ice directly on the wrist. In which direction is the thermal energy moving?

B) The thermal energy is moving from the wrist to the ice pack.

3. What happens when two substances with different temperatures come into contact?

B) Thermal energy is transferred from the warmer substance to the cooler substance.

4. Which is the best description of what happens when thermal energy is removed from a substance?

B) Its particles lose kinetic energy and move more slowly.

5. Which of the following is typically part of the knowledge base of research and development scientists working on heating devices?

A) substances and their properties

Explanation:

i just finished the quick check

the branch of optics that studies interference, diffraction, polarization, and other phenomena for which the ray approximation of geometric optics is not valid.

Answer:

3.6 s

Explanation:

100 km/hr =27.77 m/s

100/27.77=3.6 sec

Answer:

Propagation of Sound Waves:

Sound waves move (propagate) through a medium by means of particle-to-particle interaction. The source disturbs the immediately surrounding particles, causing them to vibrate about their fixed position at the same frequency as the source.

Explanation:

formula is given by

h/mv

where h is 6.626 × 10 ^-34

and c = 3 × 10^8

m = mass

by plugging in the values in the formula, the de Brogile wavelength is equal to 7.6424 × 10^(-15)

would appreciate a brainliest :)

Answer:

a large elliptical galaxy

Explanation:

(a) The relative velocity If those trucks move at the same time from the same place is 35 m/s.

(b) The distance between them after 2 minutes ​ is 4,200 m.

The relative velocity of the two truck is calculated as follows;

Vr = 20 m/s - (-15 m/s)

Vr = 20 m/s + 15 m/s

Vr = 35 m/s

d = Vr(t)

d = 35(2 x 60 s)

d = 4,200 m

Learn more about relative velocity here: https://brainly.com/question/17228388

#SPJ1

Answer:

Warm air is less dense than cold air, and warm air holds more moisture than cold air.

Explanation:

HOPE THIS HELPS AND HAVE A NICE DAY <3

Answer:

Let β = v / c          

proper time Δt'  is measured in a frame at the same place in a given frame - the proper time is measured in spaceship II moving at .28 c

a) spaceship I is moving at (.6 - .28) c = .32 c relative to proper time

Δt = Δt' / (1 - β^2)^1/2      as measured by students in ship I

Δt = 50 / (1 - .32^2)^1/2 = 52.8 m        measured by students

b) Δt = 50 / (1 - .28^2)^1/2 = 52.1 min  time elapsed for observer on earth

Answer:

The earth's axis of rotation is tilted 66.5 degrees with respect to its orbital plane around the sun and its axis of rotation is inclined 23.5 degrees from the perpendicular, with respect to this plane. The tilt of the earth affects the angle between the sun beam and the normal over a surface.

Earth orbits at an angle, so half the year, the Northern Hemisphere is tilted toward the Sun — this is summer in the Northern Hemisphere, and winter in the Southern Hemisphere. The other half of the year, the Northern Hemisphere is tilted away from the Sun, creating winter in the north and summer in the south.

When the Earth's axis is tilted toward the sun for the Northern Hemisphere, the people in the Northern Hemisphere experience summer, while at the same time, the Southern Hemisphere is tilted away from the sun and the people there experience winter.

The Northern Hemisphere receives the maximum intensity of the sun's rays, while the angle of sunlight decreases in the Southern Hemisphere.

When the sun's rays strike Earth's surface near the equator, the incoming solar radiation is more direct (nearly perpendicular or closer to a 90˚ angle). Therefore, the solar radiation is concentrated over a smaller surface area, causing warmer temperatures.

Answer:

xfxy naa

Explanation:

dhdhuciffbfjfufu

Answer:

It's D, they're all radioactive. This is due to the molecules that it is made up of

Answer:

the answer is A

Explanation:

I hope it helps you

a) For Diagram refer to the attachment.

b) The colour that dispersed most is violet.

c) Every colour has its own wavelengths/ frequency. Different colours move with same speed in air / vaccum. But their speeds in refracting media like glass are different. Therefore, refractive index of the medium for different colours is different. Some gets strongly dispersed due to shorter wavelengths.

Explanation :

[tex]\qquad\qquad\huge\underline{{\sf Answer}}[/tex]

Velocity is defined as total displacement occurrence by the given time interval, and since it's a Vector quantity it has direction as well.

So, the correct choice will be ~ B. 125 m/ East

Because it has unit of Velocity ( that is - m/s ) and it shows direction of displacement ( that is - East )

Answer:

A. Greenhouse gases

Explanation:

Because nuclear fission involves the modification of atoms.

Answer:

Greenhouse gases, because in nuclear fission, we are talking about modifying strictly atoms to get a reaction, therefore it would not make sense for greenhouse gases to be a reaction.

Resonance would occur when a vibrating tuning fork is placed near another tuning fork of the same frequency.

Resonance can be defined as a phenomenon in which a physical object is forced to vibrate due to the vibration of a second object at the same natural frequency of the first object.

This ultimately implies that, resonance is an increase in the amplitude of oscillation that only occurs when the frequency of a periodically applied force is equal to the natural frequency of a physical object such as a tuning fork, on which it's acting.

In conclusion, we can infer and logically deduce that resonance would occur when a vibrating tuning fork is placed near another tuning fork of the same frequency.

For more information on resonance here: https://brainly.com/question/9645971

#SPJ1

Answer:

8 meters

Explanation:

Frequency of waves =  5 waves / 4 s = 1.25 Hz

speed = frequency * wavelength

speed/ frequency = wavelength

  10 / 1.25 = 8 m

Answer:

b

Explanation:

The formula for work done (W) is:

W = Force x Distance moved in the direction of force

This means that the object needs to move in the direction of the force, otherwise no work is done in that direction.

Hope this helps!

149,597,871 kilometres

hope it helps...!!!