what are example for mantle
The definition of a mantle is a shawl or a cloak. An example of a mantle is a fancy shawl worn over a cocktail dress.
how has technology changed since the introduction of semiconductors.
Answer:
It has raised and evolved by being able to create different valuabes
and functionsExplanation:
Which material is not a conductor of electrical current?
A.
aluminum wire
B.
steel wool
C.
plastic coil
D.
iron filings
Answer:
plastic
Explanation:
what is the main job of a cylinder head
Answer: The function of cylinder head is to seal cylinder, form combustion space with piston, and bear the action of high temperature and high pressure gas. The cylinder head bears the mechanical load caused by the gas force and fastening the cylinder bolt, and also bears the high heat load because of the contact with the high temperature gas.
The main function of a cylinder head is to control airflow in and out of the cylinders, as well as fuel deployment.
The cylinder head is the part of an internal combustion engine that sits above the cylinders on the top of a cylinder block.The combustion gas, coolant and lubricating oil can flow freely in the cylinder head.The cylinder head is composed of the valvetrain housing, the head cover, and the combustion chamber.In conclusion, the main function of a cylinder head is to control airflow in and out of the cylinders, as well as fuel deployment.
Learn more in:
https://brainly.com/question/7441176
A vernier caliper will measure in what ( URGENT)
how do i get a used eraser out of a mechanical pencil
Answer:
Use a screw or corkscrew. Screw it into the eraser, then pull.
Cut out the eraser with a craft knife if it is already way inside.
Which of the following describes what mechanical engineers do?
they design chips and circuit boards
they develop heating and cooling systems
they develop new medical devices
they design and construct large structures
B: they develop heating and cooling systems
A would be electrical engineer.
B would be mechanical engineer.
C would be biomedical engineer.
D would be structural engineer.
When your car is broken down on the side of the road, you should make your vehicle as _____ as possible.
A. visible
B. comfortable
C. cooled
D. loud
Answer:
Visible
Explanation:
If your car is not visible you will get hit
The engineer who would be held accountable for a design flaw in a bridge
5 points
Chemical Engineer
Mechanical Engineer
Electrical Engineer
Civil Engineer
Answer:
product safety engineers
Explanation:
fax.
Answer:
B. Civil Engineers
Explanation:
took the test
What does basic levels of competence involves??
Why is it important to keep hand tools free of oil and grease?
Answer:
keeps it from rusting
Explanation:
Fred wants to help his customer understand his vision for constructing the office interior. Which visual representation will best explain Fred’s ideas?
A.
structural
B.
perspective projection
C.
auxiliary view
D.
cutting-plane view
E.
elevation drawing
Answer:
D. cutting-plane view
Explanation:
When using the cutting plane view, cutting plane lines are utilized to show a plane or planes in which a sectional view is shown. Section views give a clear indication of interior views of an object or structure including hidden parts or features which are not directly visible through convectional ways such as direct observation.
please help
please i need to turn this in
Answer: 101 means "introductory something". The allusion is to a college course with the course code 101, which in the American system and probably others indicates an introductory course, often with no prerequisites.
Explanation:
The name Topher means Christ Bearer and is of American origin. Topher is a name that's been used primarily by parents who are considering baby names for boys. Short form of Christopher.
I am not sure but if this is a trick question then the answer lies with his name, so this is the best I got. Hope it helps!
Annie has been designing a new pool filter for pools of over 5,000 gallons. The prototype she designed works well, but only on pools of less than 3,000 gallons. Which statement explains why Annie is not frustrated?
A. Engineers still need to design filters for smaller pools; this prototype can be distributed to other clients.
B. Engineers work in a cyclical process; she can just begin a totally new project.
C. Engineers can always take an existing idea and expand on it.
D. Engineers will not allow failures to stop them; a previous failure can be a practical solution for a new problem.
Answer:
C. Engineers can always take an existing idea and expand on it.
Explanation:
Engineers are problem solvers. When they identify a challenge, they design solutions and test the ideas using a prototype. When the prototype performs the desired output, they go ahead to implement a full design. This is to say, they take the existing idea that works in certain parameters and expand it to fit the intended solution.
Answer choices A,B, and D are true but not correct because the issue of frustration is not indicated. They are true because they explain the general form of working of engineers which is: continuing designing everyday to solve new problems, the work done by engineers has stages and processes and finally because engineers seek to give solutions, failure is not failing but a new problem that needs a new idea as a solution.
Answer:
c
Explanation:
Explain how an enhanced fluid power system improved efficiency in the following scenario.
Oliver has designed a new dump truck that is emitting 50 percent less carbon and needs 60 percent less fuel to run. The savings will
allow his construction company to purchase two more vehicles.
HELP !!
Answer:
He can go a few places instead doing to many pit stops
Explanation:
Answer:
The correct answer is that the system may be equipped with microstructures to reduce the friction of the fluid.
Explanation:
Oliver may have implemented a regenerative braking system, decreasing the amount of energy lost in the braking process. He also may have eliminated valves. Valves are highly susceptible to wear in a fluid power system. He may have used an actuator instead.
A guitarist would use a tuner to change which element of music?
A guitarist would use a tuner to change "pitch" of music.
An instrument having a lengthy fretting neck that is flat-bodying and generally plays strings (6) with a selection as well as fingertip, is considered as a Guitar.
An electrical gadget that receives or carries the data (signal) as well as enables consumers to observe or monitor TV, would be considered a Pitch. A sound's pitch affects the amount whereas sound intensity depending on the acoustic wave's magnitude.Bass tuners were indeed particularly designed for electric guitars as well as other string instruments, however, guitar tuners routinely operate for guitars along with the basses music.Thus the above is the right answer.
Learn more about the guitar here:
https://brainly.com/question/10328233
Wind resistance _____ as speed increases.
A. increases slowly
B. increases dramatically
C. decreases slowly
D. decreases dramatically
Answer:
B
Explanation:
No engine is perfectly efficient because?
A.society does not need efficient engines.
B.most fuel sources create environmental damage.
C.efficiency is not a goal in most engineering projects.
D.some energy will be lost to its surroundings when running.
Answer:
d
Explanation:
..............................
Which of the following would be a likely project for an engineer with a PhD degree to engage in?
meeting safety and quality standards
teaching high school mathematics
designing and building a new circuit board
conducting research on alternative energy sources
C: designing and building a new circuit board
Electrical engineers would know how to design and build a new circuit board. An engineer with a PhD would be able to do this.
Which option identifies the type of engineer most likely to be in charge in the following scenario?
A cell phone company wants to offer expanded coverage in the Andes Mountains in South America. The company hires a team of engineers to prepare a feasibility study.
civil
mechanical
agricultural
electrical
Answer:
civil engineering
Explanation:
they have survey and do construction
Answer:
its civil engineering
Why is band tension put on a bandsaw blade?
Group of answer choices
To reduce the power needed to turn the band
To keep the band tight and tracking properly
To cut more rapidly
To keep the blade cool
Vs = 9 V, I = 13.6 mA. What is R?
Answer:
661.7 ohm
Explanation:
The base formula for the solution is
[tex]i = \frac{v}{r} [/tex]
so the I is equal to V divided by R and so we can change the formula according to the given stats so we change it to
[tex]r = \frac{v}{i} [/tex]
just put the stats in V and I and you will get the answer, don forget to change the milliampere to ampere!!
Liz is creating a moving fluid system. Which of the following describes what she will need to install to create motion?
Answer:
Actuator
Explanation: Just did an assignment And got correct!
Answer:
acutator
Explanation:
Which option should the engineers focus on as they develop the train in the following scenario?
Richmond, Virginia, has recently approved the construction of a metro system throughout part of the city. As engineers study other
metro lines, they notice that there is an extreme amount of energy lost as the trains start and stop.
Engineers can design a train with additional valves to increase energy.
O Engineers can design a train with additional fluid pumps to increase efficiency
Engineers can design a train with a regenerative braking system.
Engineers can design a train involving larger hydraulic power systems.
lol
Answer:
Engineers can design a train with a regenerative braking system
Explanation:
Assuming the point of the question is that the engineers want to focus on using energy efficiently when starting and stopping, they would likely want to consider a regenerative braking system. Such a system can store energy during braking so that it can be used during starting, reducing the amount of energy that must be supplied by an outside power source.
Answer:
Engineers can design a train with a regenerative braking system
Explanation:
ur mom last night
Which of the following explains why electrical engineers take classes such as electronic techniques, microelectronic devices, networks, robotics, and integrated circuits?
to create safe stable structures
to design chips and circuit boards
to build effective communications systems
to test efficiency of energy usage
Answer:
I would honestly say D but I dont really know.
Explanation:
Helpppp!!! Used to secure lights to lighting bars and can be used when working alone to
stabilize wood onto a solid surface *
A) bungee cord
B) duct tape
C) safety cable
D) C-Clamp
The basic idea behind eco-driving is to _____ with more thoughtful driving techniques and behavior.
A. decrease or eliminate fossil fuel consumption
B. save driving time
C. reduce your drag
D. avoid collisions
Answer:
The correct answer is A
Explanation:
Can someone draw me this plz I’ll give brainlist and points I suck at drawing so._.ill give brainlist and 40 points Plz send a picture of it so I can use it for the assignment
Answer:
on computer or paper?
Explanation:
metal that does not contain
iron
Answer:
aluminum, and copper
Explanation:
hope this helps I'm not 100% sure but I think that's right
Which of the following is illegal in Florida?
A. changing your tire on the side of the road
B. turning on your hazard lights before you pull over
C. jump-starting your car on the side of the road
D. placing reflective triangles around your car on the side of the road
Answer:
Your answer is- B. Turning on your hazard lights before you pull over.
Explanation:
Hope this helps u
Crown me as brainliest:)
