What is the atomic mass, in amu, of this atom?

Answer:

AgNo3+Mgcl2--->Agcl2+Mg(No3)2

I hope this helps

Answer:

It is B

Explanation:

I was able to find my school notes and double-check. I hope you have a nice day!

Answer:

option b

Explanation:

answer from gauth math

Answer:

In atomic physics and quantum chemistry, the electron configuration is the distribution of electrons of an atom or molecule in atomic or molecular orbitals.

Answer:

False  grams is not used

Explanation:

IDEAL GAS LAW

The ideal gas law states that PV = NkT, where P is the absolute pressure of a gas, V is the volume it occupies, N is the number of atoms and molecules in the gas, and T is its absolute temperature.  

It is necessary to use Kelvin for the temperature and it is conventional to use the SI unit of liters for the volume. However, pressure is commonly measured in one of three units:  kPa ,  atm , or  mmHg . Therefore,  R  can have three different values.

Answer:

a measuring cylinder containing water only.

Explanation:

If we want to measure the volume of an irregular object. We need a properly calibrated measuring cylinder filled with water of known volume.

The irregular object is now inserted into the measuring cylinder containing water and the change in the volume of water is noted. The volume of the irregular object is now obtained as;

New volume of water - initial volume of water.

Hence, only a measuring cylinder filled with water is required to measure the volume of a small irregularly- shaped stone.

Answer:

The answer for ka is 5.26x10^-5

Explanation:

Fill in 5.26x10^-5

Answer:

Ammonium chloride, iron ,Sulphur and salt mixed together... they can be separated in the following methods.

1. Ammonium chloride is separated by sublimination... NC4CI is sublimable. Heat the mixture in a china dish and collect the funds of NC4CI (sublimable substance)

2. Bring a magnet close to the remaining mixture. Iron is magnetic substance and thus, it will be attracted towards the magnet. Iron is separated.

3. Sulphur is insoluble in water and salt is soluble. Add water to the remaining mixture and then wait for sedimentation. Separate the sulphur by decantation.

4. Heat the filtered salt solution to obtain salt.

I think there is a typo because I've never seen HSO4 2- before in my life. It should be HSO4-. For that, H is 1+ and each Oxygen is 2-0 totaling 8-. So the oxidation state of sulfur +1 - 8 = 7

So the oxidation state of sulfur is +6

Explanation:

a) m (metre)

b) mm (millimeter)

Answer:

D

Explanation:

Metallic character decreases as you move across a period in the periodic table from left to right. This occurs as atoms more readily accept electrons to fill a valence shell than lose them to remove the unfilled shell. Metallic character increases as you move down an element group in the periodic table. This is because electrons become easier to lose as the atomic radius increases, where there is less attraction between the nucleus and the valence electrons because of the increased distance between them.

Answer:

62.5 moles of O₂.

Explanation:

We'll begin by writing the balanced equation for the reaction. This is illustrated below:

2C₈H₁₈ + 25O₂ —> 16CO₂ + 18H₂O

From the balanced equation above,

2 moles of C₈H₁₈ reacted with 25 moles of O₂.

Finally, we shall determine the number of mole of O₂ needed to react with 5 moles of C₈H₁₈. This can be obtained as shown below:

From the balanced equation above,

2 moles of C₈H₁₈ reacted with 25 moles of O₂.

Therefore, 5 moles of C₈H₁₈ will react with = (5 × 25) / 2 = 62.5 moles of O₂.

Thus, 62.5 moles of O₂ is needed for the reaction.

Answer:

NAD

Explanation:

mark me brainlist please

Answer:

They lose energy which is used to form ATP

Answer:

They will be considered ions of the same element.

Explanation:

Ions form from elements when they gain or loss an electron, causing the number of protons (positively charged) to be unequal to the number of electrons (negatively charged), resulting in a net charge.

If there are more electrons than protons (from an element gaining 1 or more electrons), the ion is negatively charged and is called an anion.

If there are more protons than electrons (via the loss of electrons), the ion is positively charged and is called a cation.

Which of the following statements best explains the trends in boiling points?

A. The atomic size increases down the group, and this decreases the strength of the intermolecular forces.

                                           A is incorrect

B. The total number of electrons decreases down the group, and this decreases the strength of the intermolecular forces.

                                            B is incorrect

C. The total number of electrons increases down the group, and this increases the strength of the intermolecular forces.

                                             C is correct

D. The chances of forming a permanent dipole increases down the group, and this increases the strength of the intermolecular forces.

                                              D is incorrect

The boiling point increase down a group because the total number of electrons increases down the group, and this increases the strength of the intermolecular forces. Hence option C is correct.

Boiling point of a substance is the temperature at which the substance changes from its liquid state to vapour state. Boiling point of a molecule or compounds depends on the bond type, molecular weight, temperature and pressure.

For ionic compounds, boiling point will be higher since ionic bonds are stronger than covalent compounds. There is a periodic trend for the physical properties such as boiling point for elements in periodic table.

Down a group, the number of electrons increases and the atomic size also as well as the ionic character increases down a group . These two facts leads to higher intermolecular attraction, thus more temperature have to applied to weaken the bonds.

Higher temperature to be applied means the boiling point of the substance is higher. Therefore, boiling point down a group increases because of the higher intermolecular attraction as said in option C.

To find more about boiling point, refer the link below:

https://brainly.com/question/2153588

#SPJ1

Answer:

Pressure on Surface A > Pressure on Surface B

Explanation:

Pressu

re on Surface B > Pressure on Surface A

Answer:

you have to use the avogadro's constant of 6.023×10^23 to calculate the number of molecules of carbon dioxide.and you also have to use the molecular mass which is 44.

35.5/44×6.023×10^23

=4.85×10^23

I hope this helps and sorry if it's wrong

Answer:

0.19875

Explanation:

nFe2O3=0.099375

nFe=2nFe2O3=0.19875

Answer:

Answer: Atoms of chlorine (CI) and magnesium (Mg)

Answer: Atoms of chlorine (CI) and magnesium (Mg)is your answer

Answer:

An endothermic reaction is when heat is needed by the reaction, so it draws heat from its surroundings, making them feel cold. Just like a ice pack.

Answer:

1040

Explanation:

you can use the mole to mole ratios of aluminum chloride and hydrogen gas,you first have to find the number of moles of hydrogen gas..the number of moles of hydrogen gas are 11.7(23.4/2)

2AlCl3+3H2

2 : 3

x :11.7

3x/3=23.4/3

x=7.8g/mol

then find the number of grams of aluminum chloride

m=n×mr

=7.8×133.341

=1040g

I hope this helps and sorry if it's wrong

Answer:

TRUE

Explanation:

The blood alcohol content is also known as the blood alcohol level or the blood alcohol concentration. It is defined as the measurement of the alcohol intoxication in the body and is used for the legal or the medical purposes.

When the BAC increases in the person's body, the person started to loose clear vision, loss of short term memory, poor muscle coordination,  impaired perception and face difficulty in concentrating. Thus it becomes very difficult for a person to drive a car or ride a bike whose BAC has increased.

The driver cannot properly judge the distances between the vehicle and the speed of the vehicle.

Hence the answer is TRUE.

Answer:

The molar mass of gas Q is 43.923 g/mol

Explanation:

The given volume of ethane gas that diffuses through a porous plug in 100 seconds = 100 cm³

Therefore;

The rate of diffusion of ethane gas through the porous plug, [tex]v_{ethane}[/tex], is given as follows;

[tex]v_{ethane}[/tex] = (100 cm³/100 s) = 1 cm³/s

The molar mass of ethane, C₂H₆ = 2×12 g/mol + 6×1 g/mol = 30 g/mol

The given volume of gas, Q, that diffuses through a porous plug in 121 seconds = 100 cm³

∴ The rate of diffusion of the gas, Q, [tex]v_Q[/tex] = 100/121 cm³/s

Graham's Law of diffusion states that the rate of diffusion of a gas is inversely proportional to the square root of the molecular mass of the gas

Mathematically, we have;

[tex]\dfrac{v_A}{v_B} =\sqrt{\dfrac{m_B}{m_A} }[/tex]

Where;

[tex]v_A[/tex] = The rate of diffusion of gas A

[tex]v_B[/tex] = The rate of diffusion of gas B

[tex]m_A[/tex] = The molar mass of the gas A

[tex]m_B[/tex] = The molar mass of the gas B

Therefore, for ethane and gas Q, measured under the same condition, we have;

[tex]\dfrac{v_{ethane}}{v_Q} =\sqrt{\dfrac{m_Q}{m_{ethane}} }[/tex]

[tex]\dfrac{1 \ cm^3/s}{\dfrac{100}{121} \ cm^3/s} =\sqrt{\dfrac{m_Q}{30 \ g/mol} }[/tex]

[tex]m_Q = \left ({\dfrac{121}{100} } \right) ^2 \times 30 \ g/mol = 43.923 \ g/mol[/tex]

The molar mass of gas Q, [tex]m_Q[/tex] = 43.923 g/mol.

Answer:c

Explanation:

Answer: C

i think none of these

Explanation:

Answer:

The blue star is the hottest star.

Explanation:

Red stars are cooler than the sun, with surface temperatures of 3,500 K for a bright red star and 2,500 K for a dark red star. The hottest stars are blue, with their surface temperatures falling anywhere between 10,000 K and 50,000 K