Use the particle of theory why do solid do not flow. ​

As the redeposited minerals build up after countless water drops, a stalactite is formed. If the water that drops to the floor of the cave still has some dissolved calcite in it, it can deposit more dissolved calcite there, forming a stalagmite. Speleothems form at varying rates as calcite crystals build up. They are formed from condensation inside a cave, dripping off the ceiling.

PLEASE MARK ME BRAINLIEST

Answer:

Chemical Energy

Explanation:

Energy, Molecules and Chemical Reactions. Energy, potential energy, is stored in the covalent bonds holding atoms together in the form of molecules. This is often called chemical energy.

A. The percentage yield of gold chloride is 58%

B. The number of mole of Al produced is 40 moles

2Au + 3Cl₂ → 2AuCl₃

Molar mass of Au = 197 g/mol

Mass of Au from the balanced equation = 2 × 197 = 394 g

Molar mass of Cl₂ = 2 × 35.5 = 71 g/mol

Mass of Cl₂ from the balanced equation = 3 × 71 = 213 g

Molar mass of AuCl₃ = 197 + (3×35.5) = 303.5 g/mol

Mass of AuCl₃ from the balanced equation = 2 × 303.5 = 607 g

We'll begin by determining the limiting reactant

From the balanced equation above,

394 g of Au reacted with 213 g of Cl₂

Therefore,

39.4 g of Au will react with = (39.4 × 213) / 394 = 21.3 g of Cl₂

From the above, both Au and Cl₂ are limiting reactant.

Next, we shall determine the theoretical yield.

From the balanced equation above,

394 g of Au reacted to produce 607 g of AuCl₃

Therefore,

39.4 g of Au will react to produce = (39.4 × 607) / 394 = 60.7 g of AuCl₃

Thus, the theoretical yield of AuCl₃ is 60.7 g

Finally, we shall determine the percentage yield.

Actual yield = 35.2 g

Theoretical yield = 60.7 g

Percentage yield =?

Percentage yield = (Actual / Theoretical) × 100

Percentage yield = (35.2 / 60.7) × 100

Percentage yield = 57.99%

Percentage yield ≈ 58%

Balanced equation

2Al₂O₃ → 4Al + 3O₂

From the balanced equation above,

2 moles of Al₂O₃ produced 4 moles of Al

Therefore,

20 moles of Al₂O₃ will produce = (20 × 4) / 2 = 40 moles of Al

Thus, 40 moles of Al were obtained from the reaction.

Learn more about stoichiometry:

https://brainly.com/question/14735801

Answer:

you have school on Sunday?

Answer:

Water heats and cools more slowly than landmasses.

Explanation:

because the coastal regions will stay cooler in summer and warmer in winter but creating a more moderate climate with a narrower temperature range.

Answer: the interactions that are going on with the intermolecular. And depending how much space their is between each particle.

Explanation: Gases behave the least like ideal gases at low temperatures in high pressures because of the interactions that are going on with the intermolecular. And depending how much space their is between each particle. And whether the sizes are compared to small or large spaces are really insignificant.

Hope this helps :)

Answer:

The answer is It recognizes specific common pathogens. :)

Have an amazing day!!!

Please rate and mark brainliest!!!

Answer:

from producers to consumers

Explanation:

Energy is transferred between organisms in food webs from producers to consumers. The energy is used by organisms to carry out complex tasks. The vast majority of energy that exists in food webs originates from the sun and is converted (transformed) into chemical energy by the process of photosynthesis in plants

Short answer, don't know but i'm sure the answer is up here

Chemical weathering formed is due to acids formation when atmospheric and volcanic gases mix with water.

Chemical weathering is a type of weathering that involved weakening and disintegration of rock by chemical reactions like acid reactions and so on. These reactions include oxidation, hydrolysis, and carbonation. These processes lead to formatiom or destruction of minerals, thus changing the nature of the rock's mineral composition.

Therefore, Chemical weathering is due to acids formed when atmospheric and volcanic gases mix with water.

Learn more about chemical weathering here.

https://brainly.com/question/974321

Answer: grasshoppers produce sounds to attract mates or protect territory.

Explanation: Like their cricket cousins, grasshoppers produce sounds to attract mates or protect territory. Grasshoppers can be identified by their unique songs, which differ slightly from species to species. Grasshoppers stridulate by rubbing their wings together in the same manner as crickets.

The monomer from which the very common commercial polymer poly vinyl chloride is vinyl chloride with the formula, CH₂Cl = CH₂Cl. The PVC is formed by addition polymerization.

Polymerization is the process of combination of smaller molecules or compounds in large number to form macromolecules or polymers. There are a lot of polymers that we are using daily in the form of bags, plastics, bottles etc.

Among the common polymers we use PVC or poly vinyl chloride is very essential commercial polymer. The monomer of PVC is vinyl chlorides.

The polymerization of n vinyl chloride to form polyvinyl chloride is given below.

[tex]\rm n CH_{2}Cl = CH_{2}Cl \rightarrow (-CH_{2}Cl - CH_{2}Cl -)__{n}[/tex]

The polymerization of vinyl chloride is taking place through addition mechanism. The vinyl chloride monomer repeatedly add one by one to form the polymer.

Find more on poly(vinyl)chloride:

https://brainly.com/question/28302230

#SPJ7

The true statements is that nerve cells do not look like skin cells because they make up different organs and have different functions.

Cells are the basic functional and fundamental unit of any living organism.

Each and every cells that are present inside the body have same DNA, but they all have different function and different structures. As nerve cells are present only in the brain and spinal cord part and skin cells are present all over the body.

Hence both the cells are different as they have different functions.

To know more about cells, visit the below link:

https://brainly.com/question/13920046

#SPJ1

The sequence of coal from lowest to highest based on organic carbon contained within is peat, lignite, sub-bituminous, bituminous, anthracite.

This is a fossil fuel which is usually black in color and a combustible sedimentary rock.

There are different types of coal with the amount of organic carbon contained within from lowest to highest being shown above.

Read more about Coal here https://brainly.com/question/2051778

Answer:

To investigate the effect of changing the conditions on the rate of a reaction.

Mg(s) + 2HCl(aq) → MgCl2(aq) + H2(g

The volume of hydrogen gas produced can be measured using a gas syringe.

Method:-

- Support a gas syringe with a stand, boss and clamp.

- Using a measuring cylinder, add 50 cm3 of dilute hydrochloric acid to a conical flask.

- Add a 3 cm piece of magnesium ribbon to the flask. Immediately connect the gas syringe and start a stop clock.

- Record the volume of gas produced every 5 seconds. Continue timing until no more gas is given off.

- When the reaction is complete, clean the apparatus as directed by your teacher.

- Repeat steps 1 to 5 with different concentrations of hydrochloric acid.

I hope my answer helps you.

Answer:

Hard-boiled eggs can be preserved up to 7 days in the refrigerator.

Explanation:

The percent yield shows the extent to which the reactants are converetd into products . The limiting reactant is used up in the reaction.

A limiting reactant is the reactant that is in the least amount in the system.  Now;

Number of moles of Fe =  12.21 g/56 g/mol = 0.22 moles

Number of moles of O2 = 13.54 g/32 g/mol = 0.42 moles

Balanced reaction equation;

3Fe(s) + 2 O2(g) = Fe3O4(s)

If 3 moles of Fe reacts with 2 mole of O2

0.22 moles of Fe reacts with  0.22 moles * 2 mole/3 moles = 0.15 moles

Hence, Fe is the limiting reactant

If 3 mole of Fe produces 1 mole of  Fe3O4(s)

 0.22 moles  of O2   produces   0.22 moles * 1 mole/3 moles of  Fe3O4(s) = 0.1073 moles

Mass of  Fe3O4(s) =0.1073 moles  * 232 g/mol =16.9 g

Number of moles of excess reactant = 0.42 moles - 0.15 moles = 0.27 moles

Mass of excess reactant = 0.27 moles * 32 g/mol = 8.64 g

percent yield = 15.88 g/16.9 g * 100/1

= 93.4%

Learn more about percent yiled: https://brainly.com/question/13463225

[tex] \text{V}_1 = 50 \text{ml }\\ \text{T}_1 = 200 \text{K} \\ \text{V}_2 = ? \\ \text{T}_2 = 400 \text{K}[/tex]

[tex] \text{The Value of V}_2[/tex]

[tex]\frac{ \text{V}_1}{ \text{T}_1} = \frac{ \text{V}_2}{ \text{T}_2}[/tex]

[tex] \frac{50}{200} =\frac{ \text{V}_2}{400} \\ \\ \fbox{cross multiplying} \\ \\ \implies 200 \times V_2 = 50 \times 400 \\ \\ \implies V_2 = \frac{50 \times 400}{200} \\ \\ \implies V_2 = \frac{50 \times \cancel{ 400} { \: \: \: }^{2} }{ \cancel{200}} \\ \\ \implies V_2 = 50 \times 2 \\ \\ \implies V_2 = 100[/tex]

[tex] \therefore \implies V_2 = 100 \text{ml}[/tex]

The values of  enthalpy change, entropy change and  temperature all determine the spontenity of a reaction.

A sponteanous reaction is one which has the change in free energy as negative. We know that ΔG = ΔH - TΔS. The spontenity of a reaction depends on;

i. enthalpy change

ii. entropy change

iii. temperature

Since the values in the qestion are not given, the question is incomplete and we can not obtain a numerical value in order to decide the sponteanity of the reaction.

Learn more about sponteanous reaction: https://brainly.com/question/13790391?

ppm = mg/l = mg/kg

32 mg / 20 kg = 1.6 ppm

The concentration in ppm of sodium fluoride in tap water is 1.6 ppm.

ppm is  an abbreviation for parts per million. It can also be expressed as  milligrams per liter of a solution.It is a measurement which is equal to mass of a substance per unit volume .

One ppm is equivalent to the absolute fractional amount which is multiplied  by a million . It is a best way to describe smaller concentrations in a mixture such as that of gases,liquids or solids . It is a ratio of two quantities   which have  the same unit. In its full form ppm is expressed as one in a million part.

Depending on the substance being measured 1 ppm is expressed in many different ways, out of which preferred ways are microliters per liter , milligrams per liter and micrograms per liter.

For the given problem, concentration in ppm is found out as, since ppm is miiligrams  per liter the concentration is found out as follows:32 mg/20 kg (since kilograms  and liters  are  equivalent) =1.6 ppm

Thus, the  final concentration of sodium fluoride in tap water  which is fluorinated is 1.6 ppm.

Learn more about ppm concentration,here:

https://brainly.com/question/18090228

#SPJ2

Answer:

C

Explanation:

Amps measure the flow of Electrons

Answer:

C

Explanation:

is c

[tex]\tt [OH^-]=\sqrt{Kb.M}[/tex]

[OH⁻]=√1.76.10⁻⁵.0.188

[OH⁻]=1.81 x 10⁻³

pOH = 3 - log 1.81

pH = 11 + log 1.81

Answer:

it gives plants life and plants give us oxygen

Grasshoppers Have Ears on Their Bellies

Explanation:

Answer:

The answer is C. Inability to sleep properly for weeks.

Explanation:

This means that your mental health is going downhill because the lasck of sleep can drive you insane.

Hope This Helps!

-Justin:)

The genetic constitution of an individual, group, or class.

Explanation:

transmission of mechanisms of inherited characteristics of organisms

Answer:a trait that can be passed down is within your gens Evan if you don’t show the trait you still have the ability to pass it down

Explanation:

Based on the fact that only herbicide was used to grow the corn, this means that the resistance type of the corn are caterpillars.

Herbicide are chemicals used to control and kill weeds that could hinder crop production while insecticides are chemicals used to control insect pests.

According to this question, a field of corn was grown with 250 L/ha herbicide and no insecticide. This means that only herbs or weeds are being controlled on the field.

Therefore, it can be said that the corn plants are the type that are resistant to caterpillars, which are examples of insects.

Learn more about herbicide at: https://brainly.com/question/9166713

Answer:    

I am sure it is the reaction will shift right towards the

product