the speed of light is the ______ of its frequency and wavelength. in a vacuum, this value is a constant, ______.

Answer:

it will start moving faster and may also move away from the sun..

or if it's speed decreases it will go towards the sun and will collapse with it

brainliest plz

Answer:

140m 13 degree

Explanation:

yan po thank nalang po sa point

Explanation:

An analog signal has some feature that is a continuous function of the program material being transmitted. It may take on any of a range of values.

In radio, amplitude, frequency, or phase are features of the radio signal commonly modulated when transmitting an analog signal.

__

A digital signal has some feature that is a discrete function of the program material being transmitted. It may take on any of a specific set of values.

A digital radio signal typically uses some combination of amplitude, frequency, and phase to represent a discrete state being transmitted. Only specific values of these are used by the transmitter.

(The receiver generally has to deal with corruption of the signal by the transmission channel, so the received set of values may not correlate well with those intended at the transmitter. This is why error-correcting codes are often used with digital signal transmission.)

_____

Additional comment

Analog radio signals are generally transmitted using a carrier wave at a specific frequency (or in some specific frequency range, in the case of frequency modulation). Processing techniques may be used at the transmitter to limit the bandwidth used in the transmission. One commonly-used technique is to limit the transmitted spectrum to one side of the carrier wave frequency. (This is called "single side-band" radio.)

Digital signals offer the opportunity to transmit different bits of the information at different frequencies. Sometimes, "frequency hopping" is used, so that the transmitted carrier wave jumps around from one frequency to another in a predetermined pattern. The effect of this is to spread out the spectrum of the transmitted signal so that average power in any frequency band is significantly reduced. In fact, it may be indistinguishable from background noise, except by a receiver that tunes to the carrier wave in the predetermined frequency pattern.

Answer:

To show that magnets repel, you must place the strong and weak magnets to another magnet with their poles being both south or both north facing eachother.

To show they attract, place opposite poles near eachother.

Answer:

Tu mujhe banaye ga face dekh aapna mirror me

Answer:

iloveyouuuuuuuuuuuuuuu

Answer:

The situation is not shown, however if one calculates torques about the pivot point, then the pivot point itself exerts no torque because the force applied by the pivot point exerts zero torque because Fp * L = 0 where L = 0 in this case.

If one wants to calculate torques about, say, the end of the ruler then one would need to calculate the torque applied by the pivot point.

Answer:

1 m/s

(i think, *nervous sweat*)

Explanation:

We can tell this by looking at the graph. When t = 8, we will look at the time. We see that when the x (time) is 8, the velocity is 1 m/s.

Answer:

Un excelente ejercicio para perder barriga rápidamente es correr, ya que el cuerpo gasta una mayor cantidad de calorías en un corto período de tiempo, en tan sólo 30 minutos corriendo se queman unas 300 calorías.

...

Qué ejercicios realizar

Correr. ...

Clase aeróbica. ...

Saltar cuerda. ...

Bicicleta. ...

Caminar rápido. ...

Natación.

Explanation:

dame coronita por favor

Answer:

5 Hz

Explanation:

count the number of cycles per 1 second

Answer:

Explanation:

1The study of science and engineering should produce a sense of the process of argument necessary for advancing and defending a new idea or an explanation of a phenomenon and the norms for conducting such arguments. In that spirit, students should argue for the explanations they construct, defend their interpretations of the associated data, and advocate for the designs they propose. (NRC Framework, 2012, p. 73)

Argumentation is a process for reaching agreements about explanations and design solutions. In science, reasoning and argument based on evidence are essential in identifying the best explanation for a natural phenomenon. In engineering, reasoning and argument are needed to identify the best solution to a design problem. Student engagement in scientific argumentation is critical if students are to understand the culture in which scientists live, and how to apply science and engineering for the benefit of society. As such, argument is a process based on evidence and reasoning that leads to explanations acceptable by the scientific community and design solutions acceptable by the engineering community.

Argument in science goes beyond reaching agreements in explanations and design solutions. Whether investigating a phenomenon, testing a design, or constructing a model to provide a mechanism for an explanation, students are expected to use argumentation to listen to, compare, and evaluate competing ideas and methods based on their merits. Scientists and engineers engage in argumentation when investigating a phenomenon, testing a design solution, resolving questions about measurements, building data models, and using evidence to evaluate claims.

Compare and critique two arguments on the same topic and analyze whether they emphasize similar or different evidence and/or interpretations of facts.

Respectfully provide and receive critiques about one’s explanations, procedures, models and questions by citing relevant evidence and posing and responding to questions that elicit pertinent elaboration and detail.

Construct, use, and/or present an oral and written argument supported by empirical evidence and scientific reasoning to support or refute an explanation or a model for a phenomenon or a solution to a problem.

Make an oral or written argument that supports or refutes the advertised performance of a device, process, or system, based on empirical evidence concerning whether or not the technology meets relevant criteria and constraints.

Evaluate competing design solutions based on jointly developed and agreed-upon design criteria.

Answer: repeatable

Explanation: Accurate repeatable is needed in a valid experiment. I think

Answer:

285.7 g

Explanation:

Weight = mass x gravity

mass has units of kilograms

gravity is 9.8 m/s²

newton units are kg m / s²

So:

2.8 kg m/s² = mass x 9.8 m/s²

Divide both sides by 9.8

2.8 kg m/s²

----------------  =  mass in kg  = 0.2857kg

9.8 m/s²

Convert kilograms to grams by multiplying by 1000

0.2857kg        1000 g

--------------  X  ---------------  = 285.7g

       1                  1 kg

Answer:

The use of a telescope is to see distant objects

Explanation:

For example: you can look through a telescope to see constellations and stars. Hope this helps <3

Answer:

increase

Explanation:

I did the question

Explanation:

I don't understand this question

could you please explain

Explanation:

Well ball on ramp .Which factors are affected?

So if we put the ball right above the centre of mass it can be best stabled

Answer:

8n

Explanation

Answer:

Answer is 40m

Explanation:

The explanation is attached in the image below.

Answer:

Force arrows are used to represent both the magnitude and direction of forces. The length of the arrow corresponds to the magnitude of the force, with longer arrows indicating forces with larger magnitudes. The direction of the arrow corresponds to the actual direction that the force is being exerted. Force arrows are used by scientists and engineers to predict the motion of an object based on the forces that are applied to it.

Let's go back to Amil and his box for a moment. To represent the force that he is exerting on the box, we can draw the box and then show the force using a force arrow, like this:

Explanation:

How would our force arrow change if he pushed the box with twice as much force? Because the magnitude of the force is doubled, the length of the force arrow should also be doubled.

Now, what if he didn't push directly to the right, but instead his arms made a 30-degree angle with the ground? In that case, the direction of the force arrow needs to change to show the direction in which the force is applied.

Answer:

2)Electric charge is the physical property of matter that causes it to experience a force when placed in an electromagnetic field. Electric charge can be positive or negative (commonly carried by protons and electrons respectively)

Answer: https://www.fs.usda.gov/managing-land/urban-forests/ucf

Explanation:

if you go to this link it will give you some facts

Answer:

A book on a table before it falls.

A yoyo before it is released.

A raised weight.

Explanation:

These are all examples of potential energy. So I hope you can find something that is comparable from the lab.

Answer:

softball＝29.680365296803654

＝29.68/s

horse＝0.8km/m

satellite＝184.028km/m

Explanation:

distance/time

Answer:

1.0

Explanation:

The smallest possible value for the index of refraction is 1.0.

This talks about how fast light travels through an object by taking note of how much the light is bent, or refracted, as it enters into the material.

The smallest possible value for the index of refraction is 1.0 because the speed of light in any medium is always less than than the speed of light in air or vacuum.

Read more about Refraction here https://brainly.com/question/24319677

Answer:

the correct answer will be 6.82 %that is 7%

p(1.27)-q(0.83) =x=0.44

0.02+0.01 =0.03 (maximum uncertainty)

percentage uncertainty =0.03/0.44×100 %

=6.82%

=7%

Explanation: it was d on my end

The magnitude of velocity in east direction will be 650 N approximately.

What is velocity ?

velocity is given by the change in distance by the object with respect to change in time. It is a vector quantity and having S.I unit as m/s.

Here it is given that magnitude of velocity is 750 N and making an angle of 30 degree with x axis in counterclockwise direction as shown in figure below :

Now resolving and writing magnitude of velocity V in x and y direction respectively :

[tex]\begin{aligned}Vcos\theta&= 750 cos30^{o}=650 \:m/s\\Vsin\theta&= 750sin30^{o}= 375 m/s\end{aligned}[/tex]

It should be noted that [tex]vsin\theta[/tex] is acting in negative y direction.

Therefore, the magnitude of velocity in east direction is 650 m/s

check and know more about velocity here :

https://brainly.com/question/13563520

#SPJ2

Answer:

First you calculate the distance covered in First 3hrs then calculate the time for the remaining distance then add the total time