Please help answer the following questions ASAP

Answer:

100,000 / 800,000 = 1 / 8    amount of sample after 12 hours

(1/2)^n = 1 / 8      after n half-lives 1/8 of sample will be left

n = 3

(D) is the correct answer - 1/2 half-life = 4 hours

Answer:

A) would be the best explanation because hot air is less dense and would rise to the top of a column of air

Old potential energy:-

New potential energy

Option B is correct

The material the parachute is made out of" will not be a suitable control variable as it is needed in the research.

It should be noted that a control variable simply means any variable that is held constant in a research.

In this case, the material the parachute is made out of" will not be a suitable control variable as it is needed in the research.

Therefore, it's false.

Learn more about mass on:

https://brainly.com/question/19385703

answer is 36

because the formulae of momentum is

mass×velocity

Answer:

945 joules

Explanation:

the formula for kenetic energy is:

0.5 × m × v^2

where m is in (kg) ane (v) is in meter per second.

so we can just use the formula;

0.5 × 2.1 × 30^2

so the answer is 945 joules

When a block is made of rough surfaces, the cylinders may eventually wear to the point where repairs are ineffective.

This is the force which occurs when two surfaces slide against each other. A rough surface have more friction than a smooth surface.

Friction causes wearing out of surfaces and may render repair works done ineffective in this case.

Read more about Friction here  https://brainly.com/question/24338873

(a) The final angular velocity of the flywheel after 3 complete revolutions is 4.96 rad/s.

(b) The time taken for the flywheel to make 3 complete revolutions is 5.93 s.

The final angular velocity of the flywheel after 3 complete revolutions is determined by applying third kinematic equation as shown below;

θ = 2π (rad/rev) x (3 rev) = 18.85 rad

ωf² = ωi² + 2αθ

ωf² = (1.4)² + 2(0.6)(18.85)

ωf² = 24.58

ωf = √24.58

ωf = 4.96 rad/s

The time taken for the flywheel to make 3 complete revolutions is calculated as follows;

ωf = ωi + αt

t = (ωf  - ωi)/α

t = (4.96 - 1.4)/0.6

t = 5.93 s

Learn more about time of motion here: https://brainly.com/question/2364404

Answer:

What is the difference between a prominence and a solar flare? A prominence is a loop of cool incandescent gas that extends above the photosphere. A solar flare is an explosive release of energy that comes from the sun and causes magnetic ditrubances.

Explanation:

Answer:

F - M a      force exerted by scales on student

M a = M (9.8 + 4.9) m/s^2      upwards chosen as positive

a = 1.5 g        net acceleration of student  due to force of scales

W =M g       weight of student   (actual weight)

Wapp = M 1.5 * g      apparent weight (on scales) of student

In an elevator which is accelerating upwards with 4.9 m/[tex]s^{-2}[/tex], Mike's weight will be 1.5 times the actual weight.

Hence, the apparent weight will be 1.5 times the real weight.

To know more about the relationship between an object accelerating upwards and the weight of the object, refer:

https://brainly.com/question/2293244

#SPJ2

Revolution and rotation are the terms that describe the different movements of the earth.

Our home planet is Earth. Earth and its moon, according to scientists, originated about the same period as the rest of the solar system.

That would have been around 4.5 billion years ago, according to scientists. Earth is the solar system's fifth-largest planet.

The rotation and revolution of the earth are two different movements. The movement of the earth on its axis is known as rotation.

Revolution is the movement of the earth around the sun in a fixed route or orbit. The earth's axis, which is an imaginary line, forms a 6612° angle with its orbital plane.

Hence revolution and rotation are the terms that describe the different movements of the earth.

To learn more about the earth refer to the link;

https://brainly.com/question/14042561

The energy transformation that is happening in this process is mechanical energy to chemical energy.

According to conservation of energy, energy can not be distroyed and cannot be created, but can only be transformed from one form to another.

The batteries of some flashlights can be charged by turning a handle. The energy transformation that is happening in this process is mechanical energy to chemical energy. The chemical energy will transform to electrical energy which will eventually transform to light energy.

The turning of the handle is mechanical and the energy in battery is chemical.

Learn more about Energy here: https://brainly.com/question/25959744

One of the ways in which code of ethics does not vary from each other is ; ( C ) Principle

Code of ethics is a set of written principles that serves as a guideline to ethical behaviors expected from individuals under some form of authority usually at the place of work.

Code of ethics is different from code conduct because code of conduct is a set of rules that oultines the proper practices of individuals at the place of work. The code of ethics vary in autorship, level and purpose.

Hence we can conclude that One of the ways in which code of ethics does not vary from each other is ; ( C ) Principle

Learn more about Code of ethics : https://brainly.com/question/25717861

Answer:

12 m/sec

Explanation:

lambda = 2 m

period = 6 seconds     frequency = 1/p  = 1/6

speed = lambda * freq

            = 2 / 1/6 = 12 m/s

Answer:

donates (loses) electrons

Explanation:

Atoms are most stable when they have zero valence electrons (full octets) and have the same electron configuration as the Noble Gases.

Atoms that have 1-3 valence electrons are most likely to donate them to reach this stable configuration.

An example is Sodium (Na) has 1 valence electron, as it is group one of the periodic table, and it often forms as a positive cation (Na+1) by donating its valence electron.

An object in motion eventually stops because of friction.

Newton's first law states that if a body is at rest or moving at a constant speed in a straight line, it will remain at rest or continue its moving in a straight line at constant speed unless force is applied on it.

So we can conclude that An object in motion eventually stops is the correct answer.

Learn more about law here: https://brainly.com/question/820417

Answer:

I dont know but ask a tutor

Explanation:

MOnkey Srry

Answer:

Ethical Guidelines for Research With Human Subjects

Participation Must Be Voluntary.

Researchers Must Obtain Informed Consent.

Researchers Must Maintain Participant Confidentiality

Explanation:

Basta Yun na yan correct me if I'm wrong hehehhe

Explanation:

The center of mass of a system acted on only by internal forces cannot accelerate. without friction a car cannot move. This is a consequence of Newton's third law

Answer:

Sponges

Explanation:

It would be either sponges or flatworms.

I apologize if it is incorrect-
I hope it helps! Have a great day!

Anygays-

Answer:

7. answered because ia an pro

Explanation:

[tex]area = \frac{1}{2} bh[/tex]

[tex]area = \frac{1}{2} \times 60 \times 50[/tex]

[tex]area = \frac{3000}{2} [/tex]

[tex]area = 1500mm ^{2} [/tex]

Answer:

See below

Explanation:

Force X distance = work

 200 N * 240 m = 48 000 N-m = 48 000 j

F = ma

200 = 800 a

a = 1/4 m/s^2

d = v t  + 1/2 a t^2

12 m/s t  + 1/2  1/4 m/s^2  t^2 = 240

                shows t = 17 sec  (via Quadratic Formula)

final velocity = 12 + at = 12 + 1/4(17) = 16.26 m/s

Momentum of the given body will be : 75000 Kg m/s

According to Newton's first law of motion, all bodies continue to be in the state of rest or motion unless an external force is applied on the body. We can use this in the case of momentum also

The formula of momentum is given by :

[tex]:\implies \sf\quad \sf \: P = mv[/tex]

Here, we are given the mass of the body ( m ) as 3000kg and the velocity of the body ( v ) as 25 m/s. On putting the values in the formula:

[tex] \begin{aligned}&:\implies \sf\quad \sf \: P = mv \\& :\implies \sf\quad \sf \: P = 3000 \times 25 \\ & :\implies \sf\quad \sf \: \boxed{ \sf \: P = 75000kgm {s}^{ - 1} } \end{aligned}[/tex]

Momentum is associated with the mass of the moving body and can be defined as the quantity of motion measured as a product of mass and velocity.

Answer :-

Explanation :-

As per the provided information in the given question, we have been given that The Mass is 3000 kg . The Velocity is given as 25 m/s . And, we have been asked to calculate the Momentum .

For calculating the Momentum , we will use the Formula :-

[tex] \bigstar \: \: \: \boxed {\sf { \: Momentum \: = \: Mass \: \times \: Velocity \: }} [/tex]

Therefore , by Substituting the given values in the above Formula :-

[tex] \dag \: \: \: \sf { Momentum \: = \: Mass \: \times \: Velocity} [/tex]

[tex] \Longrightarrow \: \: \: \sf { Momentum \: = \: 3000 \: \times \: 25} [/tex]

[tex] \Longrightarrow \: \: \: \textbf {\textsf {Momentum \: = \: 75000 }} [/tex]

Hence :-

[tex] \underline {\rule {180pt} {4pt}} [/tex]

Answer:

C

Explanation:

C should be the right answer

Since the rod is held perpendicular to the direction of motion of the spaceship, the rod is 1.00 m long to an Earth observer.

To answer the question, we use the principle of length contraction in relativity.

The principle of length contraction states that the length of an object would only contraction when it is in the direction of motion.

So, since the 1.00 m long rod is in the spaceship is held perpendicular to the direction of motion of the spaceship, there is no length contraction and thus, an observer on the Earth measures the same length of 1.00 m.

So, Since the rod is held perpendicular to the direction of motion of the spaceship, the rod is 1.00 m long to an Earth observer.

Learn more about length contraction here:

https://brainly.com/question/17407131

Answer:

Look below.

Explanation:

1.) The resistance of a light bulb filament is effected by both length and cross-sectional area. Thicker wires have less resistance. A 120-Watt bulb has a greater current and a smaller resistance. Thus, a 120-Watt bulb must have a thicker filament than a 60-Watt bulb (assuming the lengths of the filaments are identical). We also think of lightbulbs in terms of their power ratings in watts. Let us compare a 25-W bulb with a 60-W bulb. Since both operate on the same voltage, the 60-W bulb must draw more current to have a greater power rating. Thus the 60-W bulb’s resistance must be lower than that of a 25-W bulb. If we increase voltage, we also increase power. For example, when a 25-W bulb that is designed to operate on 120 V is connected to 240 V, it briefly glows very brightly and then burns out. Precisely how are voltage, current, and resistance related to electric power?

2.) Energy transferred = 120 × 2 = 240 J. This equation can be rearranged to V = E ÷ Q. So voltage is energy transferred divided by charge.

3.) Power= Voltage × Current

4.) W=Pt

Answer:

E = h f      and since f = c / λ     we have E = h c / λ

Thus  λ = h c / E

Also, 1 ev = 1.6E-19 C

λ = 6.63E-34 * 3.0E8 / (1.6 * 1.6E-19)

λ = 6.63 * 3.0 / (1.6 * 1.6) * E-7

λ = 7.77E-7 = 777 nanometers

(B) is correct