Answer:
f the vapor pressure of water at 20.0 o C is 17.535 torr, and the atmospheric pressure measured by a barometer was 757.3 torr, what is the partial pressure of H2 in the gas mixture
Partial pressure of H2 in gas mixture is :
739.765 torr .
Explain total pressure?The overall pressure ptot is the total of all pressures in a reference system. This pressure, according to Bernoulli (see Fluid mechanics), consists of the static pressure p, the dynamic pressure pdyn, and the geodetic component ( g z) that exists in a fluid along a stream line in a frictionless flow.The total pressure of a gas mixture is the sum of its component gases' partial pressures: Ptot = ∑Pi = P1 + P2 + P3... ntot = total number of moles in the gas mixture (the sum of all ni).Total pressure of mixture =
Partial of hydrogen + Partial pressure of oxygen
Partial of Hydrogen = Total pressure - partial pressure of oxygen
Here total pressure = 757.3 torr
Partial pressure of oxygen = 17 . 535 torr
Total pressure = 757 . 3 - 17 . 533
= 739.765 torr.
To learn more about total pressure refer to :
https://brainly.com/question/22264785
#SPJ2
Chose any ONE state of matter and explain the space of the particles.
Use a drawing to help explain.
Answer:
solid
intermolecular space is very closed to each other and tightly packed
What makes the Earth go around the Sun?
Answer:
Just as the Moon orbits the Earth because of the pull of Earth's gravity, the Earth orbits the Sun because of the pull of the Sun's gravity. ... This happens because the Earth has a velocity in the direction perpendicular to the force of the Sun's pull.
Explanation:
Bill sets up an experiment to determine and predict the velocity of a marble at the end of a track. He uses an electronic balance to weigh the marble. He then places the marble at the top of the track and releases it. Artie uses the time it takes the marble to pass through a photogate at the bottom of the track to calculate the velocity of the marble. ill notes that his prediction is significantly higher than his calculated velocity. Which error explains this difference? A) Bill forgot to account for friction. B) Bill forgot to zero the balance and found a weight for the marble that was too low. C) Bill weighed the marble in a weighing dish and failed to account for the mass of the weighing dish. D) Bill didn't position the photogate correctly and got the time required for the top of the marble to pass through, rather than reach the middle.
Answer:
A
Explanation:
USATestPrep
Which of the following materials can conduct electricity?
Plastic pencil case
Rubber band
Steel necklace
Wood ruler
Answer:
plastics, Styrofoam, paper, rubber, glass and dry air.
Explanation:
Answer:
c
Explanation:
steel is a good conductor therefore,a steel necklace is your answer
mark my brainliest if i make sense enjoy the rest of your day!
[H+]=1×10−13 M pH=
what is this answeer
Answer:
Take the -logarithm of the concentration of hydrogen ions that are in the solution:
pH=−log(1×10−8M)=8.❤
The equations ? It’s for a chemistry class, and he said we need to explain and write down the math problems?
Answer:
I think this is because math and chemistry go together and the math problems are science related.
Explanation:
Identify one cause of the loss of forests that is not intentional.
Answer:
Natural causes are unintentional.
Explanation:
An example would be a wildfire. This natural disaster spreads quickly, especially in forests where wood burns easily. Destroying forests through burning causes nutrients to get depleted, and organisms die.
Essential Question: How is the scientific method used to answer questions?
How many atoms are present in a 0.600- mole sample of gold?
Which hypothesis is most supported by astronomers?
A- The universe is currently expanding and will continue to expand.
B- Stars could burn out, causing the universe to become dark and cold.
C- Gravity could pull galaxies back together, causing a reverse of the big bang.
D- Dark energy will pull the universe together to form a massive black hole.
HURRY!!
Answer:
option A is the most supported hypothesis by astronomers
An unknown solution contains several chemical substances. By following a series of steps in a procedure, each of these substances can be isolated. Which of the following methods would be most appropriate for showing the steps needed to separate the substances?
A. Draw a diagram of apparatus used.
B. Create a flowchart of the various steps.
C. Build a model of the various atomic structures.
D. Construct a graph showing the times needed for each step.
Answer:
Create a flowchart of the various steps.
Explanation:
Answer:
A.
Explanation:
have a nice day^^ good morning
What would happen if hydrogen chloride gas is bubbled through a solution of lead (II) nitrate? Explain
A white precipitate of silver chloride will be formed when Hydrogen chloride gas is passed through silver nitrate.
A white precipitate of silver chloride will be formed when Hydrogen chloride gas is passed through silver nitrate.2HCl+2AgNO³
→2AgCl+2HNO³
The reaction between AgCl and NH4OH will result in the products of Ag(NH3) 2+and Cl - ions .
AgCl+2NH 4OH→Ag(NH3) ²Cl+HH²O
Diazene, N2H2 (also known as diimine), is commonly used as a reagent for organic syntheses. Label each image with the type of
bond in diazene that it shows.
The first image shown at the left hand side is a pi bond. The other two images show sigma bonds.
In chemistry, a bond results from the overlap of atomic orbitals. This overlap may be end to end (sigma bond) or side by side (pi bond). Having said this, it is easier to decide whether the bonds in the image shown are sigma or bi bonds.
If we label the images; 1,2,3 from left to right, we can see that the overlap in image 1 is side by side. The electron density lies above and below the plane of the bond. This is a pi bond. In images 2 and 3, the overlap occurs in an end to end manner. This is a sigma bond.
Learn more: https://brainly.com/question/14018074
How many atoms are in 25.0 grams of carbon?
mol = 25/12
= 2.083 mol
1 mol = 6.02 × 10^23 atoms
2.083 mol = X
X = 2.083/1 × 6.02 × 10^23
= 1.254 × 10^24 atoms
This is due tomorrow please help!
Answer:
Normal Fault -> Tension
Reverse Fault -> Compression
Strike-Slip Fault -> Shearing
Explanation:
Normal Fault -> Tension
[] A normal fault is when the walls are being pulled apart and is caused by tension
[] Example:
<- ->
Reverse Fault -> Compression
[] A reverse fault is when the walls are being pushed together and is caused by compression
[] Example:
-> <-
Strike-Slip Fault -> Shearing
[] A strike-slip fault is when the walls are being pushed apart in parallel directions and is caused by shearing
[] Example:
/\ \/
Note: The page you provided also gives the answers for this specific question.
Have a nice day!
I hope this is what you are looking for, but if not - comment! I will edit and update my answer accordingly. (ノ^∇^)
- Heather
A 38-kilogram child roller skates on a circular track with a radius of 24 m. Her velocity is 6.0 m/s. What centripetal force does she experience?
580 N
0.16 N
57 N
0.38 N
Solutions which can conduct electricity must contain:
atoms
minerals
molecules
ions
Answer
Ions
Explanation
A Air at a temperature of 134°C and atmospheric pressure flows with a velocity of 7 m/s over
a smooth 5 m long and 1 m wide cast iron plate. Under steady-state conditions, the air-side
surface temperature of the plates is at 120°C. Under the described conditions, determine the
overall heat transfer rate through the plate.
B-If the flat plate in (A) is replaced with a cylinder with the same surface area (heat transfer
area) and the cylinder's length is the same as the width of the plate (1.0 m), what would be the
heat transfer rate for cross air flow over the outside surface of the cylinder?
C. If the flat plate in (A) is replaced with a sphere with the same surface area (heat transfer area),
what would be the heat transfer rate for cross air flow over the outside surface of the sphere?
D- Based on your results, discuss which surface configuration is more effective for heat
grtdggddgdggrsggrgrgd
Answer:
wut??
Explanation:
Answer all questions please and be quick, it’s very URGENT
U will get BRAINLY
Explanation:
Electric charge is the physical property of matter that causes it to experience a force when placed in an electromagnetic field. ... Electric charge is carried by subatomic particles. In ordinary matter, negativecharge is carried by electrons, and positive charge is carried by the protons in the nuclei of atoms.
Electric charge is the physical property of matter that causes it to experience a force when placed in an electromagnetic field. There are two types of electric charge: positive and negative (commonly carried by protons and electrons respectively). Like charges repel and unlike attract. An object with an absence of net charge is referred to as neutral. Early knowledge of how charged substances interact is now called classical electrodynamics, and is still accurate for problems that do not require consideration of quantum effects.
if atomic mass of Mg atom is 24g,find the mass of 1 Mg atom
Answer:
4×10^-23g
Explanation:
Given atomic mass of Mg = 24g
To find mass of 1Mg = ?
So its fix that the atomic mass of Mg 24 g is 6.022×10^23
Then the Atomic mass of 1 Mg atom is = 24 ÷ 6.022×10^23
= 4×10^-23 g
Which transition could represent an atom that emits a photon with 10.2 eVeV of energy?
Convert 23 grams of nitrogen dioxide into moles of nitrogen dioxide.
Answer:
We have to convert the following into moles.
(a) 32 g of oxygen gas = 1 mole
1 gram of oxygen gas = 1/32 mole
Given that 12 g of oxygen gas
No: of moles = given mass / molar mass
= 12 / 32 = 0.375 mole
(b) 18 g of water = 1 mole
1 gram of water = 1/18 mole
Given that 20 g of water
No: of moles = given mass / molar mass
= 20 / 18 = 1.111 mole
(c) 44 g of carbon dioxide = 1 mole
1 gram of CO2 = 1/44 mole
Given that 22 g of carbon dioxide
No: of moles = given mass / molar mass
= 22 / 44 = 0.5 mole
Explanation:
NEED ANSWER ASAP ! WILL BRAINLIST !
• Cillian is a company that uses a particular kind of wood to manufacture its products. Suppose the economy is experiencing high demand for trees from which this wood is obtained.
• Which is a likely response to this rising demand?
A. New distribution systems will be used to improve delivery of the wood to Cillian.
B. The trees will be regulated to maintain the availability of the wood.
C. New processes will be developed to locate the trees more efficiently.
D. The wood will be used as quickly as possible.
What type of material is half-life associated with?
Answer:
Radioactive material
Explanation:
A car hits a bug with a force of 100N. With how much force does the bug hit the car?
(A). 10 N
(B). 100 N
(C). 1000 N
Answer:
B
Explanation:
actin and reaction force are equal Newton 3 law
What is black powder made of? (Please provide percentage composition of elements as well) Will give brainliest
Answer:
Black powder has 3 main ingredients: Sulfur ([tex]S[/tex]), charcoal ([tex]C_{7}H_{4}O[/tex]), and potassium nitrate ([tex]KNO_{3}[/tex]).
Charcoal is basically just burnt wood and potassium nitrate can easily be displaced.
Keep in mind that this is BLACK POWDER and not actual gunpowder. The difference between the both is significant since gunpowder has a lot more refining processes it has to go through to be actually used in firearms and such.
The percentage composition of black powder should be 75% Potassium Nitrate, 10% Sulfur, and 15% charcoal.
Should be noted that black powder is not a safe compound to deal with, as static friction could ignite it.
There are other alternatives to Black powder such as nitroglycerin (used in dynamites) which is way more powerful and useful in doing mines and exploration but is an extremely tricky and reactive substance to work with.
I do hope this is just for educational purposes because you need to be certified to even just experiment with this (and there are laws to synthesize such as well, which I won't take any responsibility for)
Answer:
sulfur, charcoal and potassium nitrate
Explanation:
Payback
As atoms vibrate faster, the space between them decreases. True or false?
I belive that your answer would be False
Answer the following question attached!!
Answer:
I think It is Covalent. Not 100% sure but like 90% sure.
Question 13(Multiple Choice Worth 5 points)
(03.05 MC)
Liquid X has a pH of 7 and Liquid Y has a pH of 8.5. Which statement is true?
Liquid X is a base and Liquid Y is an acid.
Liquid X is an acid and Liquid Y is a base.
Liquid X is neutral and Liquid Y is a base.
Liquid X is an acid and Liquid Y is neutral.
Answer:
Liquid X is neutral and Liquid Y is a base
Explanation:
Acid: pH<7
Neutral: pH=7
Base: pH>7
