200 Joules should be supplied in the circuit.
Efficiency = output/inuptHere the output is 30J and input is missing
[tex]\sf \dfrac{30}{I} * 100 = 15[/tex]
multiplied with 100, to covert it into percentage
[tex]\sf 3000 = 15(I)[/tex]
[tex]\sf I = \dfrac{3000 }{15}[/tex]
[tex]\sf I = 200J[/tex]
Let that be X
Efficiency is 15% means the lamp produces 15J of light energy when 100J energy applied.[tex]\\ \rm\Rrightarrow \dfrac{30}{x}(100)=15[/tex]
[tex]\\ \rm\Rrightarrow 3000=15x[/tex]
[tex]\\ \rm\Rrightarrow x=200J[/tex]
10 POINTS
Which type of electromagnetic radiation is used in airport security screening?
O A. X-rays
• B. Ultraviolet radiation
• C. Gamma rays
O D. Infrared radiation
SUBMIT
Answer:
A) X-rays
Explanation:
Airport security screenings use X-rays because they can penetrate through bags to see objects that are located within that are obscured through normal view.
X- rays are used to test body in airports. Low energy waves are used to screen baggages and human body. Thus option A is correct.
What is electromagnetic radiation ?Electromagnetic spectrum is the arrangement of radiations in the order of decreasing wavelength or increasing energy and frequency. The order is radio waves, microwaves, infrared, visible, ultraviolet, x-rays and gamma rays.
x -rays are highly energetic short waves which can be easily penetrate through a body. X-ray is used in different diagnostic techniques. X-rays easily penetrate through tissues and provide the scanned images of internal parts.
In airport security screening x-rays are used to screen baggages and human bodies. High energetic waves are causing serious health risks. Hence, lower energy x-rays are used in testing.
To find more on x-rays, refer here:
https://brainly.com/question/2833441
#SPJ2
An eletrical conductor is a material that allows _____ to travel through it freely
Answer:
it allows electric charges to travel through freely
In addition to their remarkable top speeds of almost 60 mph, cheetahs have impressive cornering abilities. In one study, the maximum centripetal acceleration of a cheetah was measured to be 18 m/s2. What minimum value of the coefficient of static friction between the ground and the cheetah's feet is necessary to provide this acceleration?
coefficient of static friction is 1.7329
Explanation:
given data
velocity = 60 mph
acceleration = 17 m/s²
to find out
coefficient of static friction
solution
we will apply here centripetal force equation
that is
m×v²/r = µ × m × g ..................1
here v²/r is centripetal acceleration and m is mass and µ is coefficient static friction so
µ = a / g
µ = 17 / 9.81
µ = 1.7329
so coefficient of static friction is 1.7329
a 50 kg boy runs at 3 m/s. how much momentum does he have
Answer:
150 kg-m/s
Explanation:
momentum = m * v
50 * 3 = 150
A boat sails for 80 minutes and travels 3.6km. What was its average speed in m/s?
Answer:
Explanation:
The average speed of the boat:
[tex]\bar{v}=\frac{s}{t}=\frac{3.6}{80}=0.045[/tex] km/min
But if you want to change the unit into m/s, you only take this way:
[tex]0.045 \frac{km}{min}=\frac{0.045\times 1000}{60}=0.75[/tex] in m/s.
The average speed of the boat will be approximately 0.75 m/s.
What is Average speed?
Average speed is the rate of change of change of distance covered with time.
Given is a boat that sails for 80 minutes and travels 3.6 Km.
Distance covered by the boat [ΔD] = 3.6 Km = 3600 m
Time taken [Δt] = 80 minutes = 80 x 60 = 4800 s
Now, we can calculate the average speed using the formula -
s = ΔD/Δt
s = 3600/4800
s = 36/48
s = 0.75 m/s
Therefore, the average speed of the boat will be approximately 0.75 m/s.
To solve more questions on Kinematics, visit the link below-
https://brainly.com/question/15467807
#SPJ2
7. A steel band exerts a horizontal force of 80.0 N on a tooth
at point B in Figure 7.3. What is the torque on the root of
the tooth about point A?
Gum
48.0°
A
F
1.20 cm
The torque experienced by the root of the tooth about point A when the steel band exerts the given force is 0.713 Nm.
Torque about point AThe torque experienced by the root of the tooth about point A is calculated as follows;
τ = rFsinθ
where;
F is applied forcer is the perpendicular distanceτ = (0.012) x (80) x (sin 48)
τ = 0.713 Nm
Thus, the torque experienced by the root of the tooth about point A when the steel band exerts the given force is 0.713 Nm.
Learn more about torque here: https://brainly.com/question/14839816
A fish uses its tail fin to push against the water. The water is pushed backward, in the fish is pushed for it. Is it Newton's first law of motion, Newton's second law of motion, or Newton's third law of motion?
Answer:
it is Newton's third law of motion?
Hope This Helps
A 75-W light bulb is turned on. It has an operating voltage of 120 V. (A)How much current flows through the bulb? (B)What is the resistance of the bulb? (C)How much energy is used each second?
Required Answer:
Given:
Power (P) = 75 W Voltage (V) = 120 V(A)
As we know that,
I = P/V↠ Current = 75/120
↠ Current = 0.625 A
(B)
R = V/IHere,
R is resistanceV is Voltage, and I is current↠ Resistance = 120/0.625
↠ Resistance = 192 Ω
(C)
Energy = P × tHere,
P is power T is time↠ Energy = 75 × 1
↠ Energy = 75 J
Relative gravitational potential energy depends on gravity, mass, and height measured from the ____.
Answer:
We dont have a understandable Ansewer for this
Explanation:
A person sitting on a pier observes incoming waves that have a sinusoidal form with a distance of 2.5 m between the crests. If a wave laps against the pier every 5.0 s, what are (a) the frequency and (b) the speed of the wave?
Remember to identity all of your data, write the equation, and show your work. Additionally, be sure you have answered both a and b of this question.
Answer:The focal length of a lens is determined by the curve of the lens and the material that the lens is made from.
Explanation:
i just took the test
The frequency is 0.25Hz and the speed of the wave is 0.4m/s.
What is frequency and speed of the wave?Wave frequency is the number of waves that pass a fixed point in a given amount of time. This equation shows how the three factors are related: Speed = Wavelength x Wave Frequency.
To find the frequency and speed of the wave.λ=1.6m,T=4s
f=1/T
f=1/4s
f=0.25Hz
The frequency of the wave is 0.25Hz
speed=fλ
speed=(0.25×1.6)m/s
speed=0.4m/s.
The speed of the wave is 0.4m/s.
The frequency is 0.25Hz and the speed of the wave is 0.4m/s.
To learn more about the frequency and speed of the wave refer:https://brainly.com/question/3148541
#SPJ2
Many U.S. college freshman say that "being well-off" financially is an essential life goal and that "making more money" was a very important factor in their decision to attend college. According to Abram Maslow, which meta-needs are being fulfilled by "making more money"?
Based on research by Abraham Maslow, the meta-needs which are fulfilled by "making more money" are none of the meta-needs.
What are meta-needs?According to Abraham Maslow, meta-needs are human needs that relate to beauty, knowledge and creativity.
All of these can be met without having to make more money so it stands to reason that there are no meta-needs that can be met by making more money.
The main need that is met by making more money according to Maslow is Security and it is not a meta-need.
Find out more on Abraham Maslow at https://brainly.com/question/7059459.
As water is cooled, its density increases until it reaches about
O A. 25° C
B. -2° C
O c. 4°C
O D.O°C
Answer:
4 degrees C
Explanation:
this is just a 'known'
